Photosensitive organic-inorganic hybrid structures based on porous silicon

Abstract

In this study, the photovoltaic organic-inorganic structures were created by deposition of poly(3,4-ethylenedioxythiophene) film doped by poly(styrenesulfonate) and reduced graphene oxide on the porous silicon/silicon substrate. Formation of the hybrid structure was confirmed by means of atomic-force microscopy and Fourier transform infrared spectroscopy. The current-voltage characteristics of the obtained structures were studied. It was found the increase of electrical conductivity and photo-induced signal in organic-inorganic structures. Temporal parameters and spectral characteristics of photoresponse in the 400–1100?nm wavelength range were investigated. The widening of spectral photosensitivity in a short-wavelength range due to light absorption in various layers of the multijunction structure in comparison with single crystal silicon was revealed.     

单晶硅晶格间距的测量技术进展及应用

单晶硅晶格间距是许多重要物理常数测量的基础。本文介绍了硅晶格间距测量技术的发展历程,包括X射线干涉仪直接测量和晶格比较仪间接测量两种方法,以及影响测量结果不确定度的关键因素。得益于晶格间距测量的进展,在纳米尺度,硅晶格间距被国际计量局(BIPM)批准成为新的米定义复现形式。最后介绍了硅晶格在计量学中的应用,以及基于硅晶格实现纳米几何量测量的溯源体系的研究趋势。     

改进型单晶炉提拉系统偏心平衡研究

随着光伏行业的快速发展, 对硅单晶的品质和长晶装备的稳定性的要求也不断提高。直拉法是生产硅单晶的主要方法,通过提高单晶炉副室的高度以扩大单晶硅的生产规模。由于副室高度的大幅增加,且单晶炉提拉头质心相对于旋转轴心有一定距离,对单晶炉整体稳定性有较大影响,从而降低了单晶硅的生产质量。针对此问题,对单晶炉建立可靠的力学分析模型,采用数值仿真方法,对单晶炉整体进行动力学响应分析,计算得到副室高度增加后的单晶炉工作时中钨丝绳下端晶棒的运动规律以及最大摆动幅度,为改进设计提供依据。数值仿真分析表明提高单晶炉副室高度后,提拉头较大的质心偏心是单晶炉提拉系统发生摆动的主要原因。在此基础上提出在提拉头上添加质心调节装置,通过控制系统调节可保证提拉头质心位置在旋转轴线上以降低提拉系统的摆动。     

甲烷浓度对碳化硅基底金刚石薄膜摩擦性能影响

利用热丝化学气相沉积法(HFCVD)在碳化硅基底上制备金刚石薄膜,采用场发射扫描电子显微镜、拉曼光谱仪、原子力显微镜研究了在不同甲烷浓度条件下制备的金刚石薄膜表面形貌及物相组成,在干摩擦条件下通过往复式摩擦磨损实验测试并计算了已制备金刚石薄膜的摩擦系数和磨损率,结合物相分析及摩擦磨损实验结果分析了甲烷浓度的改变对金刚石薄膜摩擦磨损性能的影响。结果表明,由于甲烷气体含量的升高,金刚石薄膜结晶质量下降,薄膜由微米晶向纳米晶转变。摩擦磨损实验结果显示:3%甲烷浓度条件下制备的金刚石薄膜耐磨性较好,磨损率为2.2×10^-7 mm³/mN;5%甲烷浓度条件下制备的金刚石薄膜摩擦系数最低(0.032),磨损率为5.7×10^-7 mm³/mN,制备的金刚石薄膜的耐磨损性能相比于碳化硅基底(磨损率为9.89×10^-5 mm³/mN)提升了两个数量级,显著提高了碳化硅基底的耐磨性。     

Surface passivation in n-type silicon and its application in silicon drift detector

Based on the surface passivation of n-type silicon in a silicon drift detector(SDD), we propose a new passivation structure of SiO2/Al2O3/SiO2 passivation stacks. Since the SiO2 formed by the nitric-acid-oxidation-of-silicon(NAOS)method has good compactness and simple process, the first layer film is formed by the NAOS method. The Al2O3 film is also introduced into the passivation stacks owing to exceptional advantages such as good interface characteristic and simple process. In addition, for requirements of thickness and deposition temperature, the third layer of the SiO2 film is deposited by plasma enhanced chemical vapor deposition(PECVD). The deposition of the SiO2 film by PECVD is a low-temperature process and has a high deposition rate, which causes little damage to the device and makes the SiO2 film very suitable for serving as the third passivation layer. The passivation approach of stacks can saturate dangling bonds at the interface between stacks and the silicon substrate, and provide positive charge to optimize the field passivation of the n-type substrate.The passivation method ultimately achieves a good combination of chemical and field passivations. Experimental results show that with the passivation structure of SiO2/Al2O3/SiO2, the final minority carrier lifetime reaches 5223 μs at injection of 5×10¹⁵ cm^-3. When it is applied to the passivation of SDD, the leakage current is reduced to the order of nA.     

基于硅波导的喇曼光放大器

在硅波导上添加反向偏压的PIN结构,当波导产生受激喇曼散射时,可以将波导中双光子吸收(TPA)产生的光生自由载流子扫出波导,降低了波导的非线性损失,极大地提高了硅波导中泵浦光对信号光的喇曼增益。为了应用已经非常成熟的硅工艺,并且应用硅波导使器件小型化,根据法布里-帕罗(F-P)腔和行波放大器理论,在硅波导两端的解理面蒸镀增透膜,应用这种波导的喇曼效应设计了一种光放大器,即基于硅波导的喇曼光放大器。建立了计算放大器增益的方程,给出了不同波导长度和输入功率情况下的放大器增益,得出适当增加波导长度和泵浦光功率可以得到较高喇曼增益的结论。基于硅的光放大器有较高的饱和功率且没有泵浦源的限制,通过调整泵浦激光的波长可以放大不同波长的信号光。     

Confinement in a planar waveguide with porous silicon omnidirectional mirrors as confining walls

We present the design and study of waveguide structures based on porous silicon where the light confinement is not due to the usual total reflection effect but to the use of photonic crystals (PCs) as confining walls. These PC are omnidirectional mirrors (OMs), consisting of the periodic repetition of two porous silicon layers with different refractive indices and thicknesses. They reflect the radiation for all angles of incidence within a frequency range called the omnidirectional band gap (OBG). We have followed the PC formalism to investigate the properties of the OM as a multimode waveguide: the number of modes within the band gap, their field spatial distribution and their confinement as a function of the frequency and the core thickness.     

提高微晶硅薄膜太阳电池效率的研究

采用甚高频等离子体增强化学气相沉积技术制备了系列微晶硅薄膜太阳电池，指出了气体总流量和背反射电极的类型对电池性能参数的影响.电池的I-V测试结果表明：随反应气体总流量的增加，对应电池的短路电流密度、开路电压和填充因子都有很大程度的提高，结果使得电池的光电转换效率得以提高.另外，ZnO/Ag/Al背反射电极能明显提高电池的短路电流密度，进而也提高了电池的光电转换效率.对气体总流量和背反射电极类型影响电池效率的原因进行了分析. 关键词： 微晶硅薄膜太阳电池 气体流量 ZnO/Ag/Al背反射电极     

基于液晶光阀的全息照相控光仪

设计了通过液晶光阀自动调整全息照相物光和参考光辐照比至最佳状态,同时能实现曝光时间自动控制的控光仪.该仪器巧妙运用液晶光阀和硅光电池器件,使测量、调整、自控一体化,从而提高拍摄优质全息图的工作效率.     

微振动光电检测与数据采集系统的设计

提出了一种新的光学非接触式测量方法测量了物体的微振动振幅。用激光作为光源,以四象限硅光电池[1]作为光电探测器,借助三角测量原理,投射在振动源表面的激光反射光束在光电探测器上产生平面位移,将位移信号放大,通过A/D模块采集电压数值,并通过串口通信机制在PC终端实时显示。实验结果表明,该方法原理正确,灵敏度高,便于实现连续、快速、自动化检测,在工业在线检测方面具有良好的应用前景。